Post by s54smg2 on Jul 22, 2013 12:54:02 GMT -5
e46 m3 diy
CLEAN MASS AIR SENSOR
Parts & Tools:
SHOP
CRC Sensor Cleaner
Disclaimer: Do this procedure at your own risk! This is offered for reference only. I disclaim all liability for direct, indirect, incidental, or consequential damages or injuries that result from the use of any of these examples, instructions, or other information.
CLEAN MASS AIR SENSOR
Parts & Tools:
SHOP
CRC Sensor Cleaner- CRC mass air flow sensor cleaner
- Security Torx 20
- Rubber gloves
- squeeze the sides of the clip and pull back
- set clip aside
- using your security torx t20 remove the 2 screws holding the sensor in
- be careful when pulling out the sensor
- notice the direction of the sensor
- put on your rubber gloves
- heavily spray all areas of the sensor shown in pic below
- allow the sensor to dry completely
- re-install and you're done
- I have cleaned my OEM original MAF sensor (2005) this way every 3 months for years with no issues
Disclaimer: Do this procedure at your own risk! This is offered for reference only. I disclaim all liability for direct, indirect, incidental, or consequential damages or injuries that result from the use of any of these examples, instructions, or other information.